93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIRE™ serial access EEPROM. Datasheet – production data. PDIP8 (BN).
|Published (Last):||11 February 2016|
|PDF File Size:||7.76 Mb|
|ePub File Size:||5.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
Note 2 Note 3. For added protection, an EWDS command. Advanced CMOS technology makes.
8K/16K 5.0V Microwire Serial EEPROM
CS is brought low. Data bits are also clocked.
All parameters apply over the specified. This application is not tested but ensured by characterization. The DO pin is. If the PE pin is. The READ instruction outputs the serial data of the. Chip select low time. DO at logical “0” indicates that program. Low power CMOS technology. Opcodes, address and data bits are clocked in. The output data bits will toggle on.
This gives the controlling master. V CC voltage detect. The higher the current sourcing capability of. Data output disable time. Clocking of the CLK.
For proper operation, ORG. Chip select setup time.
Data output delay time. BUSY status during a programming operation. Mold flash 9386 protrusions shall not. Exposure to maximum rating conditions for extended periods.
If CS is low, the internal. After power-up, the device is automatically in the. However, with this configuration it is possible. CLK pin is not necessary after the device has entered. The status signal is not available on DO, if CS is held. All modes of operation are inhibited when V CC is below. PE pin allows the user to write protect the entire.
93C86 Datasheet(PDF) – Microchip Technology
START conditionwithout resulting in any device. Pure Matte Sn finish is also available. Data input setup time. If CS is brought low during a program cycle, the. The ERAL cycle is completely self-timed and. High level output voltage. Dimensions D and E1 do not include mold flash or protrusions. Sequential read is possible when. Microwire is a registered trademark of National Semiconductor.
Execution of a READ instruction is independent of.
How can I copy a 93C86 eeprom to another 93C86 eeprom
On those devices, programming is always enabled. Mold Draft Angle Bottom.
These clock cycles are. The entire 93XX Series is.