Applies to the performance in flame-exposure tests of flame-resistant fabrics of natural, synthetic, or combinations of natural and synthetic fibres, or plastic films. ELECTRONIC DRAFT COPY. CAN/ULC-S Flame Resistance of “FR NAVY” Fabric. A Report To: Safety Components Incorporated. Comparing CAN/ULC-S and NFPA – looking at the tests involved to better understand the requirements and methods.
|Published (Last):||20 November 2009|
|PDF File Size:||5.71 Mb|
|ePub File Size:||1.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
Available in all quantities. What are the steps for submitting your product?
Deterioration of coatings applied to interior finishes can occur due to cleaning, atmospheric and other conditions. Appearance – consistency and appearance of water. The issue is studied and a preliminary analysis is made The test plan is created The required samples are determined The product is then installed on the test bench The product is subjected to the test program The report is produced Contact us in order to share your needs with us so that we can help you to advance toward YOUR SOLUTION.
We issue engineering reports recognized throughout Quebec and Ontario.
ULC Fire Resistance Standards | Custom Shelters | E-Z Up Canada
Other coatings, glue, etc. May be effective over scenic paint, but must be tested for use with specific paint being used. Users of this product must determine the suitability of this product for its intended use.
Do not add water or change chemical composition in any way. We are an ISO certified lab.
Clean with soap and water all contacted areas. The user assumes all risk and liability whatsoever in connection therewith. Fire Resistance and Flammability Tests. Do not use an airless sprayer as the pressure can atomize the product, which can prevent proper performance. We can help you with: Any statement or recommendation not contained herein shall have no force or effect unless contained in an agreement signed by officers of seller and manufacturer.
Water based product, use caution when product comes in contact with metal as it may cause corrosion. Call physician if swallowed. Spray all exposed surfaces. Flush eyes with chemical eye wash or flush eyes with cool water for at least 15 minutes. Fire-poof is ready to use.
Flame retardant for fabric, wood, and other decorative materials. Polytests Services has the capacity to test a range of products including: We work in collaboration with you.
One-Stop Fire Safety Solution
Demonstrating that your product responds to requirements to meet certain standards or specifications; Measure significant parameters such as combustion temperature, product temperatures, etc. Sellers and Manufacturers only obligation shall be to replace such quantity of the product proved to be defective.
Shelf life, 5 years if unopened. Sizing, oil and dirt can also prevent absorption. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use of or inability to use the product.
Fire Retardants shall possess the desired degree of permanency and shall be maintained so as to retain the effectiveness of the treatment under the service conditions encountered in actual use.
10 x ft Poly Tarp with Fire Retardent Coating CAN/ULC-S | Princess Auto
In calling on Polytests Services for the production of your tests, you will get: M ay need to be submerged until positive results have been achieved. Apply square feet per gallon to raw wood.
Always make sure cap stays on container. Length of time may vary depending upon saturation capabilities.
Recommend wear of chemical resistant gloves, goggles and N95 mask for protection. Keep out of reach of children. Fire resistance and flammability tests Polytests Services is the laboratory of choice for the production of fire-resistant and inflammable tests. If irritation persists seek advice of a Physician. It is recommended that all fabrics be dry-cleaned. Polytests Services is the laboratory of choice for the production of fire-resistant and inflammable tests.
Designed by Wakonda Marketing. Flush sprayer and tips with warm water and wash hands with soap and water. Use only as directed. Periodic testing by a trained official should be performed to insure flame-retardant effectiveness.
Pre-vacuuming or cleaning may be needed prior to application.